No results were found for the filter!
Offers a low noise non clipping high voltage discrete buffer and return gain stage optimized for insertion between your preamp and driver stages. Installation requires 4 wires, power ground input and output. The stock setup offers a send...
Remember
Part Number: EFX-KIT-SC
The kit includes all of the parts needed to upgrade your guitar with the Mid Boost Preamp used on the Eric Clapton and Buddy Guy Strats Includes circuit board for Clapton preamp, Control 50K audio, Control 350K special taper, washer,...
Remember
Part Number: FMBK
stranded wire, 22awg. , recommended for Guitar and Bass wiring in Fender® Guitars Material: tinned copper
Remember
Part Number: CB3225
stranded wire, 22awg. , recommended for Guitar and Bass wiring in Fender® Guitars Material: tinned copper
Remember
Part Number: CB3220
SOFT TINNED COPPER WIRE Ø 0,91mm / 33 A, DIAMETER : 0.91MM (20SWG) TOLERANCE : +/- 1% ELONGATION: 22% MINIMUM RESISTANCE : 26.81 OHMS/KM STANDARD RESISTANCE @ 20 DEG C. YIELD : 5.83KGS/1000M SURFACE FINISH: THE WIRE SHALL BE BRIGHT,...
Remember
Part Number: CB4011
Includes: Volume & tone knobs, tremolo knob, switch tip, tremolo back plate, and pickup covers
Remember
Part Number: 099-1368-000
Top seller
Viewed