No results were found for the filter!
steel chassis for Blackface Vibrochamp Amp AA764 Dimeensions: H: 45mm W: 387mm D: 155mm for 2x Octalsockets (8-Pin), recommended: s8C-1 2x novalsockets (9-Pin), recommended: s9CS front: 5x pots 2x inputs 1x pilot light lamp 1x slide...
Remember
Part Number: K-ACCVC
Article with traces of usage or installation, fully functional. Tested by TAD and with full warranty ! At one point or another, it is essential for any guitarist to upgrade or replace the electronics in their guitar. Each component is...
Remember
Part Number: B-WH-T-RV-STD
Speaker (aka ''Spider'' or ''Junction'') Fiberboard, Used on Tweed Bassmans, Blackface Twins, Blackface Super, etc
Remember
Part Number: K-FBSPKR
made in the traditional way as used by Fender since the 60s till the 70s.
Remember
Part Number: K-FBCVC
made in the traditional way as used by Fender since the 50s till the 70s.
Remember
Part Number: K-FBTTLP
generic front panel for Blackface Vibrochamp Chassis K-ACCVC ca. 385mm x 48mm
Remember
Part Number: K-ACCVC-FP
Mojotone "Classic" Jazz Bass Electric Guitar Pickup Classic Jazz Bass pickups are based after the late 50's and early 60's era with more output and balance. These are smoother and warmer with a stronger low mid punch as compared to our...
Remember
Part Number: PU-JBC-N-01
This is a 3-way standard kit for our Quiet Coil Telecaster pickups that utilizes 500k potentiometers. It uses a master volume and master tone control for both pickups. Use set-screw knobs only. Included: (2) CTS 500k audio taper audio...
Remember
Part Number: WH-T-QC
Rear Panel Sticker , Blackface / Silverface Vibrochamp Style
Remember
Part Number: K-ACCVC-RP
Top seller
Viewed