No results were found for the filter!
TAD Vintage Oil Caps
The TAD Vintage Oil Caps complete our premium line of foil capacitors. Aluminum foil plates, oil dielectric. One of the best sounding audio signal capacitors ever made; smooth, natural and harmonically delightful. Superb performance in...
Remember
Part Number: V-OC002
9-PIN Tube Socket, special PC mount, phenolic
9-PIN Tube Socket, special PC mount, phenolic noval socket, PC mount for autowave solder, round pin contacts
Remember
Part Number: S9PC-2
Metall Chassis for: Wah-Wah Effectpedal for DIY-Projects
The Wah Chassis are from surplus. The devices offered are supplied completely assembled with pc board, jacks, pot, foot-switch, inductor etc. but we POINT OUT CLEARLY that we offer them just as chassis WITHOUT ANY WARRANTIE ON THE...
Remember
Part Number: EQWHA-2
Replacement pot for Chrome WAH Pdeal
100KOhms, sealed version also used on earlier TAD or RUBY(TM) WAH-WAH does not fit in Dunlop Cry Baby DISCONINUET ITEM
Remember
Part Number: POT310
6N8P / 6SN7GT Shuguang NOS
6N8P / 6SN7GT Shuguang NOS from old stock, without print marks
Remember
Part Number: NN980
SED EL34 Svetlana winged -C- / Russia
the "winged C" made in St. Petersburg factory. This tube has been the stock tube of Marshall Amplification and many others for the last decade. white boxed from production in 2000 and 2001 (samples). in 2000 the old S logo was still...
Remember
Part Number: NN251
1/4" Metal Phone Plug, mono, right angle
1/4" Metal Phone Plug, mono, right angle, replacement for CO226
Remember
Part Number: CO226-H
Guitar-pot, brass Split Shaft, 250K Audio Potentiometer, CTS
Pot for Guitar,250K-A (Audio), 1 pc., short brass split shaft. the original CTS. comes with nut, lock washer and washer like pictured special item!
Remember
Part Number: Z-A250K-BSK
Orange® Knob with set screw, for 1/4" shaft, 28
knob for Orange® Amps, 28mm Diameter,20,7mm Diameter without scale, , 15,5mm high, 1/4" shaft, with set screw UK-MADE! very close to the knobs as used on the UK made vintage Fuzz-Face
Remember
Part Number: ORK28
Output Transformer for Hiwatt Custom 200 (DR201, 4x KT88)
Output Transformer for 4xKT88,KT100 or 6550A, (Hiwatt 200, DR201) 4, 8, 16 Ohm 5 1/4" Stack: 2" Raa ca. 2.6k mounting on 92mm x 73mm-83mm (oblong hole) DC resistance: 2x 42 Ohms primary. Impedance p-p: ca. 2.2k. W x H x D: 112 x 135 x...
Remember
Part Number: TH7239
output transformer for: VOX® AC 30
output transformer for 4x EL84 Class A, sec. 8+16 Ohm, 30 Watt, for VOX AC30 of 60s +70s modelled after a Wooden 76853 lamination size: 3 3/4"(original) replacement for the 784-413 used in the UK made AC30TB and AC30TBX from 1994 to 2004...
Remember
Part Number: AC30A
Wah-Pedal Replacement pot for Dunlop and Vox Wah,
RED POT : Replacement-Pot for Vox V847, Dunlop Cry baby and many others. 150KOhms Now you have a choice of ranges for your classic Vox/Dunlop wah circuits - we offer the Blacktop at 200kL the RED-POT at 150kL and the BLUE POT at 125kL....
Remember
Part Number: POT-RED
Jupiter Condenser Round COPPER, WAX & PAPER, 0.22uF 600VDC
Jupiter Condenser COPPER, WAX & PAPER 20awg. / d=0,81mm. silver leads 0.22uF 600VDC (=220nF) size: 35x21mm Jupiter Condenser was striving to get the fullness and richness of the copper foil, the naturalness of the paper and wax, yet...
Remember
Part Number: V-JCPW220600
End bell for lamination 4 1/2" , silver
transformer mounting frame for 4 1/2" (EI114) lamination for HW100A, TG9302, SC120P etc. Mounting: 95x76mm
Remember
Part Number: TFC-41.2-R
Jensen NEO12/100 12'' 100W
End of Line - only while stock lasts A super light (2,0 kg) weight and very high efficiency speaker. Sounds very close to the mighty C12K2 but at 40% of its weight only!! Rich warm tone without the neodymium typical anoying sizzling...
Remember
Part Number: LJENEO12-16
Output transf. for Fender Twin Reverb "Ultralinear" 1975-80, 135 Watt
OUTPUTTRANSFORMER for 4x 6L6GC 135W 4/8 Ohm UltraLinear Type (with screen grid taps), max. 135W 4/8 Ohm UPGRADE for the transformator used in the 1975-1980 built 135W Fender Twin Reverb, Showman Reverb, Quad Reverb, Vibrosonic Reverb and...
Remember
Part Number: 013691
Reverb Drive Transformer, Marshall®, JCM800: 2210
Reverb drive Transformer, used in the famous JCM 800 Channel switch amps 2210, 2205, 4210, 4211, 4212. Original part #: D2967 and TXRE-00002
Remember
Part Number: M100R
6SN7GTB General Electric/USA NOS / NIB
6SN7GTB General Electric/USA NOS / NIB NOTE: unfortunately only single pieces left with different print marking and different construction details. the GTBs are reputed to among the best 6SN7 models GE every made.
Remember
Part Number: S6SN7
5-Pin Socket for 4-400C / 6775 Tetrode, equivalent to Eimac SK410
5-Pin Socket for 4-400C / 6775 Tetrode, equivalent to Eimac SK410 also for 3-500z and 3-500 tubes Discontinued ! Available only as long as stock last.
Remember
Part Number: S5-410
Jupiter Condenser Round COPPER, WAX & PAPER, 0.47uF 600VDC
Jupiter Condenser COPPER, WAX & PAPER 20awg. / d=0,81mm. silver leads 0.47uF 600VDC (=470nF) size: 52,5x21mm Jupiter Condenser was striving to get the fullness and richness of the copper foil, the naturalness of the paper and wax, yet...
Remember
Part Number: V-JCPW470600
End bell for lamination 4 1/2" (EI114), silver-zinc finish
transformer end bell for 4 1/2" (EI114) lamination, silver-zinc finish, supports slotted lamination mounting, for OR120P, OR120A
Remember
Part Number: TFC-41.2-V
Output transformer for MusicMan 135W
output transformer for Musicman 130W: Series One-Thirty (HD) Amplifiers (2-Channels) like HD-130, 210HD-130, 410HD-130 etc. Chassis Numbers: 2100-130, 2275-130 and 2475-130 with 4 x 6CA7/EL34, 4+8 Ohm also used in 100W (6L6GC) models...
Remember
Part Number: 4-130
output transformer for Marshall DSL201, JCM2000 Series
Output transformer: Marshall® DSL201, JCM2000 Serie METXOP00014 Output transformer: Marshall® DSL201, JCM2000 Serie Max. 20W, 2 x EL 84, Impedanz 8, 16 Ohm. lamination: EI57/20.5 Impedance ca. 7.7k Not suitable for Class A Operation. For...
Remember
Part Number: M20AN-1
Top seller
Viewed